12/23/08
The
rear engine's center drive was repaired by the SP at Sacramento in 1936.
They left the proof in a stamping on the end of pin that
says,
"SAC 3.3.36", "TON 125" (the pressure need to press the pin in the
wheel" and "R6 AXEL STEEL".
HP Wise Photo.
|
12/20/08
Removing the throttle. Henry Chandler steadies the casting
while Johnathon operates the forklift.
A Siegwarth Photo |
12/20/08
Alan Siegwarth working in the confines of the steam dome to get the
throttle
ready to remove.
Henry Chandler Photos |
11/29/08
Henry Chandler working in the smokebox pulling tubes.
A Siegwarth Photo |
11/29/08
Al and John putting a protective coating on the bare boiler.
A Siegwarth Photos |
11/22/08
Chris Holombo, Les Fisher and Henry Chandler (out of sight in the
smokebox) pull tubes out of the locomotive.
A Siegwarth Photo |
11/22/08
Les Fisher working on the cab floor while Kevin
Zimmerman is painting the boiler.
A Siegwarth Photo
|
11/22/08
Alan Siegwarth priming the firebox wrapper sheet
Johnathon Kruger Photo |
10/18/08
Henry Chandler and Gerald DeWitt removing tubes.
Patrice Warren Photo |
08/31/08
Carefully machining the weld/bead off of the tubes.
A Siegwarth Photo |
08/31/08
Charlie and Jeff in the firebox with a tube cutter installed
and ready
to cut the seal weld and bead from the rear tube
sheet. Removing the
weld and bead will allow the tube to be pushed out of the sheet from
the firebox end.
A Siegwarth Photo |
Now that the forklift is in place, how were we
going to get this tank
off again? Chris Holombo, Henry Chandler and Johnathon Kruger
discuss
rigging the tank to the forklift. |
Happy operator now that Pettibone is in place
between the #4 and passenger cars stored on yard track #1 |
06/14/08
Pettibone forklift maneuvered into tight quarters ready to lift the
side tank off of the locomotive.
A Siegwarth photo |
06/14/08
Henry Chandler removing tank mounting bolts in preparation for removing
the firemans side tank.
A Siegwarth Photo |
05/31/08
Chris Holombo, Les Fisher, Henry Chandler removing lots piping to get
access to remove the Mallets side tanks. |
09/29/07
A proud cleaning crew - Chris Holombo, Gerald DeWitt, Dave
Loyola, Charles Franz, Jeff Schwab and Alan Siegwarth |
09/27/07
Cleaning scale out of boiler. Chemicals were added
to the boiler and water heated to boiling point for improved scale
removal. Notice the steam coming out of the open steam dome
which was
left uncovered to prevent pressure buildup in the boiler. |